Shinju Variation of Rope bondage

Rope bondage - Tutorial 3a - Shinju Variation

There are a lot of different variations on the basic Shinju tie. It's one reason why it is easily the most popular. You dont have to start right at this point, or with exactly this pattern to make this add-on work.Just follow the basic principles, and make a few things up as you go

Here we are at the back of the finished Shinju covered in Tutorial 3. We want to add some rope.Take a doubled length of rope and knot it to this portion of your workings

Rope bondage -Shinju Variation 1

I'm going to tie my bight off to this section, and rather than just securing it to the horizontal ropes. I'm making sure to go also around the vertical part that is holding the wrists up. This will prevent the ropes from loosening unintentionally as the knot might slide a bit with tension if only fixed on one axis. The knot is a simple over hand knot. You could also use a lark's head - I often do here- but by knotting this rather than running your working ends through the bight, it is easier to undo or shift around later.

Rope bondage -Shinju Variation 2

There. Note that with the original tie, there are four lines above the breasts, and two below. What we're going to do is make this whole thing more secure

Rope bondage -Shinju Variation 3

The doubled rope goes around the front, and under the breasts once

Rope bondage -Shinju Variation 4

Here it is from the front

Pass the working end behind a vertical element and then up to the top of the center knot ...

Rope bondage -Shinju Variation 5

There as on we went up with the last rope becomes clear - as we then create this diagonal from that point to just above the elbow that's both structurally sound and good looking. Then the rope goes under the arms and to the other side.

Rope bondage -Shinju Variation 6

Around your diagonal, adjusting for position and tension for this new element, and back again the same way, between the arms and the back ...

Rope bondage -Shinju Variation 7

Again, to even out the tension, pass this rope around the section you just did.

Rope bondage -Shinju Variation 8

And now we see one of the great reasons for leaving those small loops. Remember how the wrist tie had that small loop?Well, here we put it to use, threading our two loose ends of rope through the loop on the wrist ...

Rope bondage -Shinju Variation 9

And then up to just above the ropes that cross the upper arms

Rope bondage -Shinju Variation 9

Wrap around the body and back down through the loop at the wrists. You'll get a front view in a moment, but from here you'll want to tie off in some fashion --we'redone

Rope bondage -Shinju Variation 10

Here's a view from the front. Note that we now have six ropes running above the breasts, four below, and four keeping the elbows in place around the arms in back. Tie off your rope in any fashion you like

Here's aside view.

And a rear view with a simple bow.

Rope bondage -Shinju Variation 

Read More

Rope bondage - tutorial 3 - Shinju

Rope bondage - tutorial3 - Shinju

Breast bondage is a bondage technique which involves the tying of rope around a woman's breasts in a visually intricate and decorative pattern. Breast bondage most commonly uses rope, but webbing, straps or a harness may also be used. A karada (Japanese for "body") is a rope dress or a rope body harness used in Japanese bondage and other BDSM activities.[1]

Breast bondage often focuses on the decorative, aesthetic and erotic aspects of the result, and not on immobilization of the female subject. However, breast bondage can be combined with other techniques which restrict the subject's mobility and can provide securing points for other bondage plays, such as crotch rope and tit torture.

Shinju (from the Japanese 真珠 meaning pearl) is a euphemism to refer to the binding of female breasts. It has been popularly claimed that "shinju" is an authentic Japanese term for a "bikini harness". However, no such tie called a "shinju" is found in historic or present kinbaku.

The basic or foundational kinbaku form of binding the arms and breasts is known as the Ushiro Takatekote; which is to bind the arms behind (ushiro) the back in a box arm position (takate kote). This basic box arm tie originally found in the samurai martial art of hojōjutsu (捕縄術) or Nawajutsu, (縄術) evolved into its erotic usage at the end of the 19th century and early 20th century, and is foundational to most other kinbaku ties.
( see more at : http://en.wikipedia.org/wiki/Shinju_(BDSM) )

Here we start by having our subject place their hands in back

Rope bondage Shinju 1

With the now familiar doubled length of rope,measure enough of the looped end to wrap around the wrists two or three times. The reason we do this with the bight end is so that we don't have to run the entire long end around the wrists-- pretty obvious, but in the heat of play you forget these kinds of things.

Rope bondage Shinju 2

Leave a little extra

Rope bondage Shinju 3

... wrap the looped end behind all the strands. This is so that when pulled, the rope won't noose upon the wrists under pressure and cut off circulation in the wrists..

Rope bondage Shinju 4

Tie off with a simple square knot, leaving a tad bit of loop to possibly be used later.

Rope bondage Shinju 5

Next, take the loose end around the front, over the breasts. Keep tension on this line with the right hand as well. Why will become apparent in a moment ...

Rope bondage Shinju 6

...because the next step is to run your line behind that spot and support the wrists.

Rope bondage Shinju 7

Pull up a bit to get things centered.

Rope bondage Shinju 8

And wrap around the front, on top of the breasts again. Lineup your rope strands for that clean look .

Rope bondage Shinju 9

Catch the center section going the other way.

Rope bondage Shinju 10

Then go once under the breasts. This is how it should look from the front.

Rope bondage Shinju 11

... and the back.

Rope bondage Shinju 12

Rope bondage Shinju 13

Just wrap to balance this out before the next steps...

 And now under one arm and towards the front ...

Rope bondage Shinju 14

... and under the bottom strands.Another good way to do this is to bring the top strands down a bit on the arms and cinch both top and bottom together, but we're just going to do the bottom ones in this tutorial

There..Cinch it up a bit ...

And bring it to the rear.

Rope bondage Shinju 15

Do the same with the other side.

Rope bondage Shinju 16

One last knot, and you're done.

Rope bondage Shinju 17

There we go.

Rope bondage - tutorial 3 - Shinju

See more : 

Shinju Variation of Rope bondage

Read More

Rope bondage tutorial 2 - Simple Breast Tie

Rope Bondage tutorial 2 - Simple Breast Tie

PART 1:
Start by doubling a twenty-five or thirty foot length of rope. Wrap around the top of the breasts once.

Rope Bondage Simple Breast Tie 1

Catch this in the back with a lark's head knot.

Rope Bondage Simple Breast Tie 2

Wrap again around the front, making sure your ropes line up evenly.

Rope Bondage Simple Breast Tie 3

Run your lines through the lark's head, evening out the tension

Rope Bondage Simple Breast Tie 4

Another wrap around in the other direction,underneath the breasts.

Rope Bondage Simple Breast Tie 5

Bring the end of the rope through to the back again.

Rope Bondage Simple Breast Tie 6

Now I'm going to finish this with a kind of over-large bow for illustration purposes, but there are any number of methods to do this.

Rope Bondage Simple Breast Tie 7

Even things out a bit and ...

Rope Bondage Simple Breast Tie 8

Here we are- four strands above, and two below.                                                                                        

 

PART 2:

On to part two. Start again by doubling your rope,then tie a knot around the center section

Rope Bondage Simple Breast Tie 9

What knot, you might ask. Well, use a simple overhand knot here- make'sit easier to untie later (than a lark's head.) With hemp, this will hold, but you might want to go with a square knot or something else, especially if you're not using hemp

Rope Bondage Simple Breast Tie 10

Pass once around, underneath the breasts...

Rope Bondage Simple Breast Tie 11

After sliding the rope to catch its own starting pair of strands, and bring the working end up. It's best to go from one side, and then over the opposite shoulder, otherwise you get a kind of suspender straps kind of thing, which isn't what we're going for in this one. Ignore the two dangling strands here- they're left over from when we shortened up those large loops earlier.

Rope Bondage Simple Breast Tie 12

Now, once under the bottom four strands.

Rope Bondage Simple Breast Tie 13

A couple of simple crossings- I know, my hand's in the way. Just hit next...

Rope Bondage Simple Breast Tie 14

There. 

Rope Bondage Simple Breast Tie

Read More